The Colossus electronic ballast was specially created for dual-use lamps. This ballast is suitable for HPS/400V, LEC 630 and LEC 1000 bulbs. It has a microprocessor controlled which maintains the lumen level of the lamp longer than traditional ballasts.
Low switch-on level at only 3A per device and IP43 protection. It is very light and silent, and can be mounted on the wall. With thermal and circuit protection. Intelligent "soft-start" digital technology. In combination with Solux 600 and 1000 W lamps, the best results are obtained.

The Colossus electronic ballast was specially created for dual-use lamps. This ballast is suitable for HPS/400V, LEC 630 and LEC 1000 bulbs. It has a microprocessor controlled which maintains the lumen level of the lamp longer than traditional ballasts.
Low switch-on level at only 3A per device and IP43 protection. It is very light and silent, and can be mounted on the wall. With thermal and circuit protection. Intelligent "soft-start" digital technology. In combination with Solux 600 and 1000 W lamps, the best results are obtained.

Solux presents the new Selecta I 315 and Selecta II 630W LEC (Light Emitting Ceramic) electronic devices. These units use an innovative technology of low frequency and square waves, which allow to maintain an efficiency greater than 95% after 30,000 hours of operation and without changing the spectrum of the lamp, providing safety and efficiency.
These appliances operate between 120 and 240V, so they are suitable for industrial and domestic use. They also have a potentiometer to adjust the power at any time. In addition, they have an RJ connection that allows you to connect them to the Solux Master Controller (they also work with the Gavita Master Controller) for total control of the device in your grow room.

Solux presents the new Selecta I 315 and Selecta II 630W LEC (Light Emitting Ceramic) electronic devices. These units use an innovative technology of low frequency and square waves, which allow to maintain an efficiency greater than 95% after 30,000 hours of operation and without changing the spectrum of the lamp, providing safety and efficiency.
These appliances operate between 120 and 240V, so they are suitable for industrial and domestic use. They also have a potentiometer to adjust the power at any time. In addition, they have an RJ connection that allows you to connect them to the Solux Master Controller (they also work with the Gavita Master Controller) for total control of the device in your grow room.

Solux presents this 1000W Spectra luminaire for double socket lamps, with open reflector, specially designed for professional applications.
The Spectra luminaire has multiple functions: potentiometer to adjust the intensity between 600-1150W; Smart Step technology to reduce the output of a lamp; Super Lumen function to obtain the maximum output of a lamp; Smart Start function; Soft Start technology able to extend the life of the lamp; re-ignition of the hot lamp after a power failure; compatibility with multiple lamps; automatic frequency regulation and circuit protection.

Solux presents this 1000W Spectra luminaire for double socket lamps, with open reflector, specially designed for professional applications.
The Spectra luminaire has multiple functions: potentiometer to adjust the intensity between 600-1150W; Smart Step technology to reduce the output of a lamp; Super Lumen function to obtain the maximum output of a lamp; Smart Start function; Soft Start technology able to extend the life of the lamp; re-ignition of the hot lamp after a power failure; compatibility with multiple lamps; automatic frequency regulation and circuit protection.

Solux presents the new Selecta I 315w and Selecta II 630W LEC (Light Emitting Ceramic) electronic devices. These units use a new low frequency and square wave technology, which allows to maintain an efficiency above 95% after 30,000 hours of operation and without changing the spectrum of the lamp, providing safety and efficiency.
These appliances operate between 120 and 240 V, so they are suitable for industrial and domestic use. They also have a potentiometer to adjust the power to the needs of the gardener at all times. In addition, they have an RJ connection that allows you to connect them to the Solux Master Controller (they also work with the Gavita Master Controller) for total control of the unit in your grow room.

Solux presents the new Selecta I 315w and Selecta II 630W LEC (Light Emitting Ceramic) electronic devices. These units use a new low frequency and square wave technology, which allows to maintain an efficiency above 95% after 30,000 hours of operation and without changing the spectrum of the lamp, providing safety and efficiency.
These appliances operate between 120 and 240 V, so they are suitable for industrial and domestic use. They also have a potentiometer to adjust the power to the needs of the gardener at all times. In addition, they have an RJ connection that allows you to connect them to the Solux Master Controller (they also work with the Gavita Master Controller) for total control of the unit in your grow room.

Solux presents the new Selecta I 315w and Selecta II 630W LEC (Light Emitting Ceramic) electronic devices. These units use a new low frequency and square wave technology, which allows to maintain an efficiency above 95% after 30,000 hours of operation and without changing the spectrum of the lamp, providing safety and efficiency.
These appliances operate between 120 and 240 V, so they are suitable for industrial and domestic use. They also have a potentiometer to adjust the power to the needs of the gardener at all times. In addition, they have an RJ connection that allows you to connect them to the Solux Master Controller (they also work with the Gavita Master Controller) for total control of the unit in your grow room.

Solux presents the new Selecta I 315w and Selecta II 630W LEC (Light Emitting Ceramic) electronic devices. These units use a new low frequency and square wave technology, which allows to maintain an efficiency above 95% after 30,000 hours of operation and without changing the spectrum of the lamp, providing safety and efficiency.
These appliances operate between 120 and 240 V, so they are suitable for industrial and domestic use. They also have a potentiometer to adjust the power to the needs of the gardener at all times. In addition, they have an RJ connection that allows you to connect them to the Solux Master Controller (they also work with the Gavita Master Controller) for total control of the unit in your grow room.

Solux presents the new Selecta I 500W LEC (Light Emitting Ceramic) electronic devices. This luminaire includes the 500w - 4200k lec pro bulb.
These units use a new low frequency and square wave technology, which allow to maintain an efficiency of more than 95% after 30,000 hours of operation and without changing the spectrum of the lamp , providing safety and efficiency. These appliances are suitable for industrial and domestic use. They also have a potentiometer to adjust the power to the needs of the gardener at all times. In addition, they have an RJ connection that allows you to connect them to the Solux Master Controller Solux master controller (612150) for total control of the device in the growing environment.

This lamp consists of a ballast and a reflector and can be purchased with or without lamps.
Two LEC 3100K lamps or two LEC 4200K lamps are required with this fixture.

This lamp consists of a ballast and a reflector and can be purchased with or without lamps.
Two LEC 3100K lamps or two LEC 4200K lamps are required with this fixture.
With Lamp Included

This lamp consists of a ballast and a reflector and can be purchased with or without lamps.
Two LEC 3100K lamps or two LEC 4200K lamps are required with this fixture.
With Lamp Included

Solux presents the new Selecta I 315 and Selecta II 630W LEC (Light Emitting Ceramic) electronic devices. These units use an innovative technology of low frequency and square waves, which allow to maintain an efficiency greater than 95% after 30,000 hours of operation and without changing the spectrum of the lamp, providing safety and efficiency.
These appliances operate between 120 and 240V, so they are suitable for industrial and domestic use. They also have a potentiometer to adjust the power at any time. In addition, they have an RJ connection that allows you to connect them to the Solux Master Controller (they also work with the Gavita Master Controller) for total control of the device in your grow room.

The Sun System LEC315 uses the most advanced technology in the industry, the LEC (Light Emitting Ceramic). Its interior is made of 98% reflective aluminum and its corners are made of 95% textured aluminum for excellent light distribution and uniformity.
Phillips' new CDM-T Elite ceramic lamps have increased their light spectrum, leaving behind sodium and halides.
The construction of these lamps together with the design of the luminaire, considerably reduces the heat emitted so that the open luminaire is used. The luminaire incorporates its own special electronic ballast for the CDM-T Elite lamp.Phillips lamp included. The covered area is 1'10m² optimal.

Weight :5 kg
315 W

Solux presents the new Selecta I 315 and Selecta II 630W LEC (Light Emitting Ceramic) electronic devices. These units use an innovative technology of low frequency and square waves, which allow to maintain an efficiency greater than 95% after 30,000 hours of operation and without changing the spectrum of the lamp, providing safety and efficiency.
These appliances operate between 120 and 240V, so they are suitable for industrial and domestic use. They also have a potentiometer to adjust the power at any time. In addition, they have an RJ connection that allows you to connect them to the Solux Master Controller (they also work with the Gavita Master Controller) for total control of the device in your grow room.

This reliable 315W CMH digital ballast uses square wave technology to efficiently ignite and operate 315W metal halide lamps (also known as CMH / CDM / LEC).
CMH technology creates high energy PAR / PPF levels with low heat full spectrum that is closer to sunlight and produces healthy growth and higher yield.
This ballast is for use with Lumatek 315W CMH lamp for grow lighting (4200K Daylight and 3100K Agro available) and is also Phillips compatible. For safety, this ballast uses full circuit protection including open/short circuit, over temperature, over/under voltage, lamp end of life/rectification and EMI suppression

This reliable 630W CMH digital ballast uses square wave technology to efficiently ignite and operate 315W metal halide lamps (also known as CMH / CDM / LEC).
CMH technology creates high energy PAR / PPF levels with low heat full spectrum that is closer to sunlight and produces healthy growth and higher yield.
This ballast is for use with Lumatek 315W CMH lamp for grow lighting (4200K Daylight and 3100K Agro available) and is also Phillips compatible. For safety, this ballast uses full circuit protection including open/short circuit, over temperature, over/under voltage, lamp end of life/rectification and EMI suppression

Lumatek UTOPIA CMH Dimmable 315W with compact reflector. It is an all-in-one integrated device combining Lumatek controllable electronic ballast, compact reflector and 315W CMH lamp.
The e-ballast can be controlled remotely with a Lumatek digital control panel (sold separately) and is dimmable.
The reliable 315W CMH digital system from  has been successfully used in grow facilities around the world and uses square wave technology to shoot and use effectively efficient 315W ceramic metal halide lamps (also known as CMH / CDM / LEC).

The Agrolite reflector is a high performance reflector with integrated and dimmable ballast, this type of reflector can therefore be used in all stages of plants without any problems. Thanks to the built-in dimmer, you can also choose the power and consumption you prefer. This type of reflector allows us to extend the life of the lamps and to have an even more complete spectrum composition than HPS systems.

The Agrolite reflector is a high output double ended reflector with integrated and dimmable ballast, this type of reflector can therefore be used in all stages of plants without any problems. Thanks to the built-in dimmer, you can also choose the power and consumption you prefer. This type of reflector allows us to extend the life of the lamps and to have an even more complete spectrum composition than HPS systems.

The high-performance Elektrox reflector with integrated and dimmable ballast can be used in all phases of plants without any problems. Thanks to the built-in dimmer, you can also choose the power and consumption you prefer.
This type of reflector allows us to lengthen the life of the lamps and to have a more complete spectrum composition compared to HPS systems.>
IT DOES NOT INCLUDE THE LAMP!

Watt :315
Socket:PGZ18

Solux presents the new Selecta I 315w and Selecta II 630W LEC (Light Emitting Ceramic) electronic devices. These units use a new low frequency and square wave technology, which allows to maintain an efficiency above 95% after 30,000 hours of operation and without changing the spectrum of the lamp, providing safety and efficiency.
These appliances operate between 120 and 240 V, so they are suitable for industrial and domestic use. They also have a potentiometer to adjust the power to the needs of the gardener at all times. In addition, they have an RJ connection that allows you to connect them to the Solux Master Controller (they also work with the Gavita Master Controller) for total control of the unit in your grow room.